Home > Ticket 8 – Switchport VLAN 10

Ticket 8 – Switchport VLAN 10

April 29th, 2018 Go to comments

Configuration of ASW1
interface FastEthernet1/0/1
  switchport mode access
!
interface FastEthernet1/0/2
  switchport mode access
!

 

Answer:

Ans1) ASW1
Ans2) Access Vlans
Ans3) In Configuration mode, using the ‘interface range Fastethernet 1/0/1 – 2’, then ‘switchport access vlan 10’ command.

Note: In this ticket, although Fa1/0/1 is not assigned an VLAN ID but it can still receive an IP address from DHCP server as it will belong to VLAN 1 by default

Comments (5) Comments
  1. Majid
    January 24th, 2020

    In GNS3 labs, following comment is not valid and not working.
    “Note: In this ticket, although Fa1/0/1 is not assigned an VLAN ID but it can still receive an IP address from DHCP server as it will belong to VLAN 1 by default”.

    As you can see ASW-1 and DSW-1 connection is on Ether-Trunk who only allows Vlans 10 and 200. Then how come any traffic on VLAN-1 or Default VLAN can pass through this trunk interface ??

  2. GG
    February 1st, 2020

    Try this:

    1. check the config on R4 for EIGRP

    2. then add the following config
    router eigrp 10
    network 10.2.0.0 0.0.255.255

  3. GG
    February 1st, 2020

    I missed. It’s DSW

  4. Rofl
    February 5th, 2020

    @LOL good job, you played yourself
    “@dandelion301 , A , how did you get your CCNA”
    “A. In Configuration mode, using the interface range Fastethernet 1/0/1 -2,
    then switchport mode access vlan 10 command”

    switchport access vlan 10 is correct. NOT switchport MODE access vlan 10

    @dandelion301
    The answers seems a little bit strange, because in my lab trunk or shutdown is not configured on the fa 0/1 and 0/2, but the only valid switchport access command is from answer D and the other 2 commands are unnecessary, but not wrong.

  5. MALIKA
    February 6th, 2020

    Hi @ networktut the configurations on the client and sw1 are not being displayed,there are error messages ,kindly fix