Share your ENARSI v1.1 Experience

@Lemmel did you you take your exam? how did it go?

@Raptors when are you taking it? I will take it July 2nd. By looking at everyones suggestions, I a VRF Lab eigrp/ospf , one DMVPN EIGRP/OSPF , one Netflow lab is what we can expect.

That is probably the most likely set of labs that will appear. However, based on my experience with Cisco exams, they can change at any time. That’s why it’s important to be familiar with all of them, as the labs on the actual exam will most likely be similar to these. It’s best to be prepared for everything.

If you don’t mind, could you please share your experience after taking the exam? I would really appreciate hearing about it.

@Munty I’m taking the test on July 7th, I’d appreciate any updates, and good luck.

I am preparing for end of this month… read cert guide twice (as usual you find in exam details not shown there), made a syntaxes extract, watched 70% of Arash Deljoo ENARSI videos, some GNS3 fiddling, several questions to AI. Began yesterday with labs here, hope to close’em before tomorrow (currently forging a booklet of them to print and reharse later). Then I will start quizzes.

During these last weeks will reharse the labs booklet plus the syntaxes extract and try to compete the videos. My encor is not away from expiry, this exam has been my time-nightmare during the past months and still will be till the end. After reading labs I totally agree that, within that tight time constraint, at least half of them could get you in trouble. Sadly the biz of making people repeat hefty exams is quite unfair. Thanks @Networktut!!!!

Guys passed today, Labs were as I predicted, scored 100% in all categories

VRF Eigrp: Same to same as the the one here. There were ACL Block lists configured on R3, but were not applied in any interface. so just keep watch and remove auto summary in all eigrp

Netflow: The Netflow lab 1 from here, ip addresses were same as well

DMVPN OSPF: Configure the Branches. Task was to ensure encrypted tunnel and OSPF reachability. All were preconfigured, I had to add ip nhrp nhs, remove tunnel dest and add gre multipoint, Ipsec configs had mode transport configured it to mode tunnel for encryption, ensured ospf priority was 0

No drag and drop, questions were between part 3 to part 8

Thank you @networktut.

Good luck guys, I would suggest take the exam asap within 5 days from today. Cant be easier then this

Big compliments Munty!!!
And thanks for your hints, I’ll place those labs at the beginning of my booklet!

Raptors c’mon! Kick their $400 butts!

Thx Munty, I will take the test on July 8th.

Hello. Where to get ENARSI dumps? can you share? or if i subscribe here in networktut, is there ENARSI dumps included?

Passed today, 40 questions + 3 labs. Many questions were same to those here and other were similar.

Labs not exactly the same, but similar:
– VRF Eigrp
– Netflow
– DMVPN OSPF

Kudos to Xpert!!! Thx for latest news!
Waiting for Raptors and Atsiz!
C’mon, beat the sleaze!

I passed the exam today!
40 questions + 3 labs,
– VRF Eigrp authentication IN R3 and need to config on R4
– DMVPN OSPF
– Netflow
Good luck everyone, it’s super easy, I suggest taking it now.

I failed my exam today. I had the same labs that everyone has been reporting.

The VRF & EIGRP lab was almost identical to the one on the site. I did not see an access-group on R3.

On the DHCP/IP SLA lab, I felt pretty confident until I got to adding the ip helper-address 10.1.1.1. I got hung up there.

Unfortunately, I didn’t have enough time to finish the DMVPN lab.

Most of the multiple-choice questions came directly from this site, so I definitely recommend studying it. I’ve already rescheduled my exam for next week.

Good luck to everyone taking the exam!

I am taking my exam soon, will come back here after my exam

I passed the exam today
Mine started with a lab tasks right away, which was pretty stressful.

DMVPN/OSPF: I had to configure IPsec and crypto on HO based on B1, using both tunnel mode and transport mode. It took me quite a while to figure out where the mistake was.
VRF/EIGRP: There was an ACL blocking the traffic, so I had to fix that first, then configure authentication. In Task 3, I also had to configure IP summarization on R6, even though that isn’t mentioned anywhere on this site.
SLA/DHCP/NetFlow: This lab was also different. In Task 2, I had to configure IP SLA 1 with tracking to the Internet on port 80, similar to dhcp-ip-sla-netflow-2, but with some differences.
I also had 3 new questions on SNMP and PBR, plus a few questions from Parts 1 and 2.
There were no drag-and-drop questions.
Thanks, @Networktut! Wishing everyone the best of luck with the exam!

Raptors and Atsiz, well done!!! Now you are CCNPs!!!
@Atsiz: in DMVPN the problem was figuring out transport vs tunnel mode or something else?

C’mon Lemmel and Xoro, I’m with you with all heart!!!

@Atsiz what do you mean by “using both tunnel mode and transport mode.”?

@Atsiz, were there any ipv6 questions

@The Butcher, thank you bro!
All three tunnel interfaces were already configured (including ip nhrp map, ip nhrp nhs, MTU, and OSPF priority). I had to troubleshoot the issue on H0.

Initially, I changed the IPsec transform set to tunnel mode on all three devices. However, H0 was actually configured with transport mode. After changing the IPsec transform set on H0 to match the others, the DMVPN tunnel came up and show dmvpn displayed the DMVPN neighbors correctly.

@Siuuu, There were definitely IPv6 questions in my exam.

Hello. Where to get ENARSI dumps? or if i subscribe here in networktut, is there ENARSI dumps included? Or need to check Questions Sections each?

@Atsiz, welldone .

Can you give details on the IP summarization you did on the lab

Hi, may I know how trustable this site? Because it seems like this site does not have much dumps compared to their CCNA and ENCOR website.

Passed the exam. 41/43 questions were from here. Labs are similar but tasks are different. for VRF eigrp, you need to configure eigrp authentication md5 on one interface. Please practice all questions throuhgly from here and prepare DMVPN/OSPF, VRF/EIGRP and Netflow labs and you should be good to pass.

Thank you Networktut and the community here!! Can someone please tell me any reliable stie for fortinet/palo alto questions?

Congratulations xoro!!!!!!!

Were questions mostly fresh ones or older ones?

I passed today!

This time around, I focused a lot more on the DMVPN lab. Regarding that lab, most of the configuration was already completed. I only had to configure the NHRP network-id, NHRP NHS, and the IPsec transform set. My biggest advice is to make sure you read every task carefully and fully understand what each question is asking before you start configuring.

This was my second attempt. I failed the exam last Monday, regrouped, and came back today to pass.

Also, neither of my exams had any drag-and-drop questions.

Regarding the IP SLA lab, it was very similar to the one that’s been shared here. If you’ve practiced that lab, you’ll be in good shape.

Good luck to everyone taking the exam!

Lemmel! I was thinking about your exam! YAY!!! Well done!!!!
300$ less but one CCNP more! :))))

Also thanks for all your precious feedback!
QUESTION: were questions more from last parts (7+8) or more mixed with past ones?

Hey everyone exam passed today
40mcq with 2 drag and drops (5 new questions)
VRF EIGRP with simple config no md5 no access-lists, no summary routes,
DMVPNwith EIGRP (config in HO and 2 important command!), no ipsec
Netflow

Thanks for preparing me for that networktut

Good luck it is not rocket science but read the tasks carefully!

Big congrats!!!!

Failed today. DMVPN similar. EIGRP completely diffrent task- hard to understand the goal. netflow completely diffrent than here with diffrent tasks. mcq 43 75% percent is from here. exam is way more harder than the tasks here. it is extremly hard to complete everything. you have to lab every possible scenario to EVENTUALLY even think about passing.

Hi Butcher, I don’t remember but I thoroughly prepared all of them and would recommend you to take your time and do the same to pass in first attempt.

Guys

I passed my examen,

+ 43 mcq.
+ LAB Sims: DMVP over OSPF, VRF over EIGRP and DHCP | IPSla | Netflow.

Thanks for everything networktut

Good luck to everyone taking the exam